A-A-52205
2.4 Load capacity. The table shall support a weight of 80 pounds in its fully opened position distributed over an area measurement 18 inches by 18 inches in the center of the table top.
2.5 Surface finishing.
2.5.1 Preparation. Surfaces to be painted shall be free of burrs, slivers, cracks, scale, rough or sharp edges and foreign matter. They shall be cleaned, conditioned and primed, as appropriate, prior to painting.
2.5.2 Painting. All exterior surfaces of the table shall be painted green (see 6.4). The paint utilized shall not contain lead or chromate. Painted surfaces shall be continuous, smooth and adherent, without runs, drops, streaks, pin holes, cheeks, cracks or voids. The coating shall be free from imbedded foreign matter and shall not reveal peeling, flaking or blistering.
2.6 Legs. The legs shall have positive acting locking devices when the table is fully opened and fully closed. Leg bottoms shall be equipped with closures (leg tips) for floor protection.
2.7 Drop test. A folded table shall be capable of being dropped on each corner from a height of two feet onto a smooth hard surface without structural damage, cracking or denting.
2.8 Metric products. Products manufactured to metric dimensions will be considered on an equal basis with those manufactured using inch-pound units, provided they fall within the tolerances specified using conversion tables contained in the latest revision of ASTM E 380, and all other requirements of this document are met. If a product is manufactured to metric dimensions and those dimensions exceed the tolerances specified in the inch-pound units, a request should be
made to the contracting officer to determine if the product is acceptable. The contracting officer has the option of accepting or rejecting the product.
3. REGULATORY REQUIREMENTS
3.1 Contractor-recovered materials. The offeror/contractor is encouraged to use recovered materials to the maximum extent practicable, in accordance with paragraph 23.403 of the Federal Acquisition Regulation (FAR).
4. QUALITY ASSURANCE PROVISIONS
4.1 Product conformance. The products provided shall meet the salient characteristics of this commercial item description, shall conform to the producer's own drawings, specifications,
2
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business